Please follow these steps to properly place your sticker

E

Step 1 Press down on all your lettering (transfer paper side) with a scraper provided for this purpose.

Step 2 Start by gently removing the transfer paper (the thickest). Your lettering must stick to the transfer paper, which will allow an easy installation. If not, you probably did not press hard enough in the previous step.

Step 3 Using a spray, moisten the surface (previously cleaned and degreased) where you want to stick the sticker, as well as the sticker and its transfer paper, with soapy water.

Step 4 Place the sticker and its transfer paper on the wet surface, and position it as you wish on the surface.

Step 5 Once in place, apply pressure with the squeegee to the entire sticker to remove the soapy water.

Step 6 Wait until the assembly is dry, then carefully remove the transfer paper.

Step 7 Your sticker is stuck on your support, the installation is now finished!